FRONT DOOR SPEAKER (for Sedan): Installation

HINT:

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY 
   1. Using an air riveter or hand riveter, install the front No. 1 speaker with 3 new strike rivets.

      HINT:

      Install the new strike rivets in the order shown in the illustration.

      Fig 1: Installing Strike Rivets

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      • Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.
        Fig 2: Precaution For Installation Of Rivets (1 Of 3)

        Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • Confirm that the rivets are seated properly against the speaker.
      • Do not tilt the riveter when installing the rivet onto the speaker.
      • Do not leave any space between the rivet head and speaker.
        Fig 3: Precaution For Installation Of Rivets (2 Of 3)

        Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • Do not leave any space between the speaker and door. Firmly hold the 2 items together while installing the rivet.
        Fig 4: Precaution For Installation Of Rivets (3 Of 3)

        Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Connect the speaker connector.
   Fig 5: Locating Speaker Connector
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY  (See REASSEMBLY )
3. INSTALL FRONT DOOR ARMREST BASE UPPER PANEL  (See REASSEMBLY )
4. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH  (See REASSEMBLY )
5. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)  (See REASSEMBLY )
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

   Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)