STEERING COLUMN ASSEMBLY (for Hatchback): Disassembly

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE STEERING SLIDING YOKE SUB-ASSEMBLY
1. Place matchmarks on No. 2 steering intermediate shaft assembly and the steering sliding yoke.
2. Remove bolt A and remove the steering sliding yoke from No. 2 steering intermediate shaft.
  
  Fig 1: Identifying Matchmarks On Steering Intermediate Shaft Assembly No. 2 & Steering Sliding Yoke
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE TRANSPONDER KEY AMPLIFIER
1. Disengage the 2 claws and slide the transponder key amplifier in the direction shown, to detach it from the steering column upper with switch bracket assembly.
  
  Fig 2: Removing Transponder Key Amplifier
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE STEERING COLUMN UPPER
1. Fix the steering column assembly in a vise between aluminum plates.
  NOTE: Do not overtighten the vise.
2. Using a drill, drill a hole in each of the 2 steering lock set bolts, to insert a screw extractor.
3. Using the screw extractor, remove the 2 steering lock set bolts and remove the steering column upper w/ switch bracket assembly and steering column clamp upper.
  
  Fig 3: Removing Steering Lock Set Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY
1. Turn the ignition switch to ACC.
2. Insert the tip of a screwdriver into the hole in the steering column bracket assembly upper and pull the ignition switch lock cylinder assembly out until its claw comes into contact with the stopper of the steering column bracket assembly upper.
  
  Fig 4: Inserting Tip Of Screwdriver Into Hole In Steering Column Bracket Assembly Upper
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE: Pull the ignition switch lock cylinder assembly out until its claw comes into contact with the stopper of the steering column bracket assembly upper. Otherwise, the following procedure cannot be conducted properly.
3. Insert the tip of a screwdriver into the hole in the steering column bracket and tilt it downward to disengage the claw of the ignition switch lock cylinder. Then pull out the ignition switch lock cylinder.
  
  Fig 5: Removing Ignition Switch Lock Cylinder
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE UNLOCK WARNING SWITCH ASSEMBLY
1. Push up the unlock warning switch assembly center portion to disengage the 2 claws.
  HINT:
  
  Slide the unlock warning switch assembly, in the direction shown by the arrow, to remove it.
  
  Fig 6: Locating Unlock Warning Switch Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE KEY INTER LOCK SOLENOID (for Automatic Transaxle)
1. Remove the 2 screws and remove the key lock solenoid from the steering column bracket assembly upper.
  
  Fig 7: Locating Key Inter Lock Solenoid (For Automatic Transaxle)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE IGNITION OR STARTER SWITCH ASSEMBLY
1. Disengage the 2 claws and remove the ignition (starter) switch assembly from the steering column bracket assembly upper.
  
  Fig 8: Identifying Ignition (Starter) Switch Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002