Spiral Cable: Inspection
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT SPIRAL CABLE
- Check the spiral cable.
- Using an ohmmeter, measure the resistance between the terminals.
SST 09082-00030
- Set the spiral cable in the center and measure the resistance in each position where the spiral cable is turned 2.5 times clockwise and counterclockwise.
- Turn the spiral cable 2.5 times clockwise from its original position and measure the resistance while turning it 5 times counterclockwise.
Standard resistance
TESTER CONNECTION SPECIFIED CONDITIONTester Connection Specified Condition A1(D-)-D2(D-) Below 1 Ω A2(D+)-D1(D+) Below 1 Ω B1(D2-)-D3(D2-) Below 1 Ω A2(D2+) - D4(D2+) Below 1 Ω NOTE: To avoid breakage of the spiral cable, do not turn the spiral cable more than necessary. If the result is not as specified, replace the spiral cable.
- Using an ohmmeter, measure the resistance between the terminals.
- Check the spiral cable.