On-Vehicle Inspection

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT REAR AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)
1. Perform a diagnostic system check (See DTC CHECK / CLEAR ).
INSPECT REAR AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
CAUTION: For rear airbag sensor removal and installation procedures, see REMOVAL and INSTALLATION and carefully follow the correct procedure.
1. Perform a diagnostic system check (See DTC CHECK / CLEAR ).
2. When the center pillar of the vehicle or its periphery is damaged, check whether there is any damage to the rear airbag sensor. If there are any defects, such as those mentioned below, replace the rear airbag sensor with a new one:
  - Any cracks, dents or chips in the case.
  - Any cracks or other damage to the connector.
  - Peeling of the label or damage to the serial number.
INSPECT REAR AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision)
CAUTION: For rear airbag sensor removal and installation procedures, see REMOVAL and INSTALLATION and carefully follow the correct procedure.
1. Replace the rear airbag sensor.