LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Supplemental Restraint System) >> Occupant Classification System >> Precaution

Occupant Classification System: Precaution

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECTION PROCEDURE FOR VEHICLE INVOLVED IN ACCIDENT 
    1. Perform the zero point calibration and sensitivity check if any of the following conditions apply.
      • The occupant classification ECU is replaced.
      • Accessories (seatback tray and seat cover, etc.) are installed.
      • The front passenger seat is removed from the vehicle.
      • The passenger airbag ON/OFF indicator (OFF) comes on when the front passenger seat is not occupied.
      • The vehicle is brought to the workshop for repair due to an accident or a collision.
      NOTE: When an accident vehicle is brought into the workshop for repair, check the flatness of the floor where the front passenger seat is mounted. If the flatness is not within +- 3.0 mm (0.118 in.), adjust it to the specified range.
scientia non olet · About LEMON Manuals