On-Vehicle Inspection

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT OCCUPANT CLASSIFICATION ECU (for Vehicle not Involved in Collision)
1. Perform a diagnostic system check (See DTC CHECK / CLEAR ).
REMOVE OCCUPANT CLASSIFICATION ECU (for Vehicle Involved in Collision)
1. Perform a diagnostic system check (See DTC CHECK / CLEAR ).
2. Even if the airbag was not deployed, check if there is any damage to the occupant classification ECU. If there are any defects as those mentioned below, replace the occupant classification ECU with a new one:
  - Cracks, dents or chips in the case.
  - Cracks or other damage to the connector.
  CAUTION: Follow the correct removal and installation procedures.