SIDE MUDGUARD (for Hatchback): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

Fig 1: Identifying Double-Sided Adhesive Tape Of Side Mudguard Protector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL SIDE MUDGUARD PROTECTOR

Install a new side mudguard protector onto the side mudguard.

Installation position:

MARK MEASUREMENT CHART

Mark	Measurement
a	1 mm (0.039 in.)

Fig 2: Identifying Side Mudguard Protector Clearance

INSTALL SIDE MUDGUARD
1. Engage the 8 clips and install the side mudguard.
2. Press the double-sided adhesive tape of the side mudguard protector.
  
  Fig 3: Identifying Double-Sided Adhesive Tape Of Side Mudguard Protector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the 8 retainers.
4. Tighten the screw.
  
  Fig 4: Locating Retainers
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002