ROOF DRIP SIDE FINISH MOLDING (for Hatchback): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

REMOVE ROOF DRIP SIDE FINISH MOLDING
1. Apply protective tape to the roof panel in the area around the roof drip side finish molding.
  
  Fig 1: Applying Protective Tape To Roof Panel
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disengage the 2 clips and remove the roof drip side finish molding.
  NOTE:
  - Do not remove the clips.
  - Replace the clips with supply clips if damaged.