REAR SPOILER (for Sedan): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE REAR SPOILER SUB-ASSEMBLY
1. Disconnect the center stop light connector.
2. Remove the 2 bolts.
  
  Fig 1: Locating Center Stop Light Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Apply protective tape to the luggage compartment door panel in the periphery of the rear spoiler.
4. Using an infrared light, heat the adhesive tape remaining on the rear spoiler.
  HINT:
  
  Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.
5. Tie both piano wire ends to wooden blocks or similar objects.
  
  Fig 2: Applying Protective Tape To Luggage Compartment Door Panel
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Cut the adhesive tape by pulling the piano wire alternatively toward you.
7. When reusing the rear spoiler, set the wooden blocks or similar objects along the body to avoid damaging the rear spoiler end portion.
  
  Fig 3: Cutting Adhesive Tape By Pulling
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. Disengage the 2 clips and remove the rear spoiler.
  
  Fig 4: Identifying Clips And Rear Spoiler
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002