REAR SPOILER (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR SPOILER PROTECTOR SIDE LH
NOTE: Follow these procedures only when replacing the protector.
1. Apply a new rear spoiler protector to the rear spoiler installation surface as shown in the illustration.
INSTALL REAR SPOILER PROTECTOR SIDE RH
HINT:

Use the same procedure as for the LH side.

Fig 1: Applying Rear Spoiler Protector To Rear Spoiler
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR SPOILER SUB-ASSEMBLY
1. Clean the rear spoiler (When reusing the rear spoiler).
  1. Using an infrared light, heat the double-sided adhesive tape remaining on the luggage compartment door panel.
    HINT:
    
    Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.
  2. Using a shop rag or piece of cloth, rub the remaining double-sided adhesive tape off the rear spoiler while it is hot from the infrared light.
    NOTE: Installing the rear spoiler while any double-sided adhesive tape remains on the luggage compartment door panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.
  3. Using white gasoline, clean the rear spoiler.
  4. Apply new double-sided adhesive tape to the rear spoiler installation surface as shown in the illustration.
2. Clean the attachment surface.
  1. Using an infrared light, heat the double-sided adhesive tape remaining on the luggage compartment door panel.
    HINT:
    
    Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.
    
    Fig 2: Applying Rear Spoiler Protector To Rear Spoiler
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Using a shop rag or piece of cloth, rub the remaining double-sided adhesive tape off the luggage compartment door panel while it is hot from the infrared light.
    NOTE: Installing the rear spoiler while any double-sided adhesive tape remains on the luggage compartment door panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.
  3. Using white gasoline, clean the attachment surface.
3. Install the wire harness into the luggage compartment door panel hole.
4. Engage the 2 clips and install the rear spoiler.
5. Remove the protective tape.
  
  Fig 3: Identifying Clips And Rear Spoiler
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Tighten the 2 bolts.
7. Connect the center stop light connector.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

Fig 4: Locating Center Stop Light Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002