REAR BUMPER (for Hatchback): Reassembly

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL LICENSE PLATE LIGHT ASSEMBLY
1. Engage the 2 claws and install the license plate light.
  
  Fig 1: Locating Claws And License Plate Light
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR BUMPER ENERGY ABSORBER LH
1. Apply 2 new pieces of tape.
  
  Fig 2: Identifying Pieces Of Tape
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the rear bumper energy absorber with the clip.
INSTALL REAR BUMPER ENERGY ABSORBER RH
HINT:

Use the same procedure as for the LH side.

Fig 3: Locating Rear Bumper Energy Absorber
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002