NO. 3 BLACK OUT TAPE (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The procedure described below is for the LH side. Use the same procedure for the RH and LH sides, unless otherwise specified.

INSTALL NO. 3 BLACK OUT TAPE

Application precautions (See INSTALLATION ).
Clean the attachment surface (Using an infrared light) (See INSTALLATION ).
Clean the attachment surface (Using a tape removal disc) (See INSTALLATION ).

Apply new No. 1 black out tape to the positions shown in the illustration.

Fig 1: No. 1 Black Out Tape Positions Chart

Installation position

MARK MEASUREMENT CHART

Mark	Measurement (along surface)
a	+-1 mm (+-0.039 In.)
b	11 to 13 mm (0.433 to 0.512 in.)
c	10 to 12 mm (0.394 to 0.472 In.)