NO. 3 BLACK OUT TAPE (for Hatchback): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The procedure described below is for the LH side. Use the same procedure for the RH and LH sides, unless otherwise specified.

REMOVE NO. 3 BLACK OUT TAPE
1. Using an infrared light, heat the black out tape.
  NOTE: Do not burn yourself with the heated front door panel or infrared light.
  
  HINT:
  
  Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.
2. Lift the end portion with your nail and peel it parallel to the attachment surface.
  
  Fig 1: Identifying Black Out Tape
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002