NO. 3 BLACK OUT TAPE (for Hatchback): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

INSTALL NO. 3 BLACK OUT TAPE

Application precautions (See INSTALLATION ).
Clean the attachment surface (using an infrared light) (See INSTALLATION ).
Clean the attachment surface (using a tape removal disc) (See INSTALLATION ).

Apply new black out tape to the positions shown in the illustration.

Fig 1: Black Out Tape Positions Chart

Installation position

MARK MEASUREMENT CHART

Mark	Measurement (along surface)
a	+-1 mm (+-0.039ln.)
b	4 mm or more (0.157 In. or more)
c	+-1 mm (+-0.039ln.)