FRONT PILLAR UPPER COVER (for Sedan): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

REMOVE FRONT PILLAR UPPER COVER
1. Apply protective tape, as shown in the illustration.
  
  Fig 1: Applying Protective Tape
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a molding remover, disengage the 2 clips and the claw and remove the front pillar upper cover.