FRONT PILLAR UPPER COVER (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

Fig 1: Identifying Claws And Clips Location

INSTALL FRONT PILLAR UPPER COVER
1. Engage the 2 clips and the claw and install the front pillar upper cover.
  
  Fig 2: Identifying Claws And Clips Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the protective tape.
  
  Fig 3: Applying Protective Tape
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002