FRONT BUMPER (for Hatchback): Disassembly

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE FRONT BUMPER PAD
1. Remove the front bumper pad.
REMOVE RADIATOR GRILLE EMBLEM (See REMOVAL )

Fig 1: Identifying Front Bumper Pad
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE RADIATOR GRILLE
1. Using a screwdriver, disengage the 14 claws and remove the radiator grille.
  
  Fig 2: Identifying Claws Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE RADIATOR LOWER GRILLE
1. Disengage the 11 claws and remove the radiator lower grille.
  
  Fig 3: Identifying Claws Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FOG LIGHT ASSEMBLY LH
1. Remove the screw and the fog light.
REMOVE FOG LIGHT ASSEMBLY RH
HINT:

Use the same procedure as for the LH side.

Fig 4: Locating Screw And Fog Light
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FOG LIGHT COVER LH
1. w/ Fog Light:
  1. Disengage the 5 claws and remove the fog light cover.
    
    Fig 5: Identifying Claws Location
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. w/o Fog Light:
  1. Disengage the 5 claws and remove the fog light cover.
REMOVE FOG LIGHT COVER RH
HINT:

Use the same procedure as for the LH side.

Fig 6: Identifying Claws Location
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT BUMPER HOLE COVER
1. Disengage the 3 claws and remove the front bumper hole cover.
  
  Fig 7: Identifying Claws Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002