OUTER MIRROR SWITCH (for Sedan): Inspection
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT OUTER MIRROR SWITCH
- Check the resistance.
- Select L on the left/right adjustment switch.
- Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in TESTER CONNECTION SPECIFIED CONDITION TABLE
.
Standard Resistance
TESTER CONNECTION SPECIFIED CONDITION TABLETester Connection Condition Specified Condition - OFF 10 k ohms or higher 4 (VL) - 8 (B)
6 (M+) - 7 (E)UP Below 1 ohms 4 (VL) - 7 (E)
6 (M+) - 8 (B)DOWN Below 1 ohms 5 (HL) - 8 (B)
6 (M+) - 7 (E)LEFT Below 1 ohms 5 (HL) -7 (E)
6 (M+) - 8 (B)RIGHT Below 1 ohms If the result is not as specified, replace the outer mirror switch.
- Select R on the left/right adjustment switch.
- Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in TESTER CONNECTION SPECIFIED CONDITION TABLE
.
Standard Resistance
TESTER CONNECTION SPECIFIED CONDITION TABLETester Connection Condition Specified Condition - OFF 10 k ohms or higher 3 (VR) - 8 (B)
6 (M+) - 7 (E)UP Below 1 ohms 3 (VR) - 7 (E)
6 (M+) - 8 (B)DOWN Below 1 ohms 2 (HR) - 8 (B)
6 (M+) - 7 (E)LEFT Below 1 ohms 2 (HR) - 7 (E)
6 (M+) - 8 (B)RIGHT Below 1 ohms If the result is not as specified, replace the outer mirror switch.
- Check the resistance.