On-Vehicle Inspection
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT STARTER RELAY ASSEMBLY
- Check the resistance.
- Using an ohmmeter, measure the resistance between the terminals.
Standard resistance
STARTER RELAY ASSEMBLY
| Tester Connection |
Specified Condition |
| 3-5 |
Below 1 ohms (when battery voltage applied to terminals 1 and 2) |
| 10 k ohms or higher |
If the result is not as specified, replace the relay.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002