Acc Cut Relay: Inspection
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT ACC CUT RELAY
- Check the resistance.
- Using an ohmmeter, measure the resistance between the terminals. Standard resistanceACC CUT RELAY
Tester Connection Specified Condition 3-4 Below 1 ohms 10 k ohms or higher (when battery voltage applied to terminals 1 and 2) 3-5 Below 1 ohms (when battery voltage applied to terminals 1 and 2) 10 k ohms or higher If the result is not as specified, replace the relay.
- Using an ohmmeter, measure the resistance between the terminals. Standard resistance
- Check the resistance.