STOP LIGHT SWITCH (for Hatchback): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STOP LIGHT SWITCH
1. Install the stop light switch into the adjuster until it slightly touches the brake pedal.
  NOTE: Do not depress the brake pedal.
  
  Fig 1: Identifying Stop Light Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Make a quarter turn clockwise to install the stop light switch.
    NOTE: Do not depress the brake pedal.
    
    HINT:
    
    The turning torque for installing the stop light switch is as below.
    
    Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf) or less
2. Check the stop light switch clearance.
  Stop light switch clearance: 0.5 to 2.6 mm (0.020 to 0.102 in.)
3. Connect the stop light switch connector to the stop light switch.
  
  Fig 2: Identifying Stop Light Switch Clearance
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY LH (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

Fig 3: Checking Stop Light Switch Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002