LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 187 (Lighting System) >> STOP LIGHT SWITCH (for Hatchback) >> Inspection

STOP LIGHT SWITCH (for Hatchback): Inspection

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT STOP LIGHT SWITCH 
    1. Check the resistance.
      1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

        Standard Resistance 

        TESTER CONNECTION SPECIFIED CONDITION CHART

        Tester Connection Condition Specified Condition
        1-2 Switch pin released Below 1 Ω
        3-4 Switch pin released 10 kΩ or higher
        1-2 Switch pin pushed in 10 kΩ or higher
        3-4 Switch pin pushed in Below 1 Ω

        If the result is not as specified, replace the stop light switch.

        Fig 1: Identifying Terminals Of Stop Light Switch Connector
        G04832662Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals