SIDE TURN SIGNAL LIGHT ASSEMBLY (for Hatchback): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY
1. Disengage the 2 claws and disconnect the side turn signal light.
2. Disconnect the connector and remove the side turn signal light.
  
  Fig 1: Locating Side Turn Signal Light Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002