Rear Door Courtesy Switch: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR DOOR COURTESY SWITCH
1. Using "Torx" socket wrench T30, install the rear door courtesy switch with the screw.
  Torque: 3.7 N*m (38 kgf*cm, 33 in.*lbf)
  
  Fig 1: Locating Rear Door Courtesy Switch Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
1. Install the rear door opening trim weatherstrip.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

Fig 2: Identifying Rear Door Opening Trim Weatherstrip
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002