Rear Door Courtesy Switch: Inspection
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT REAR DOOR COURTESY SWITCH
- Check the resistance.
- Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
Standard Resistance
TESTER CONNECTION SPECIFIED CONDITION CHARTTester Connection Condition Specified Condition 1 - Switch body ON (Shaft not pressed) Below 1 Ω 1 - Switch body OFF (Shaft pressed) 10 kΩ or higher If the result is not as specified, replace the rear door courtesy switch.
- Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
- Check the resistance.