REAR COMBINATION LIGHT ASSEMBLY (for Sedan): Removal
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure described below is for the LH side.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- REMOVE LUGGAGE COMPARTMENT FLOOR MAT
- Remove the luggage compartment floor mat.
- REMOVE SPARE WHEEL COVER ASSEMBLY
- Remove the spare wheel cover assembly.
- REMOVE DECK FLOOR BOX LH
- Remove the deck floor box with the deck side box door.
- REMOVE DECK FLOOR BOX RH
HINT:
Use the same procedure as for the LH side.
- REMOVE REAR FLOOR FINISH PLATE
- Disengage the 2 clips and the rear floor finish plate.
- REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER
- Disengage the 5 clips and remove the luggage compartment trim inner cover.
- REMOVE REAR COMBINATION LIGHT ASSEMBLY
- Remove the 2 nuts.
- Disconnect the connector.
- Slide the rear combination light assembly toward the rear of the vehicle.
- REMOVE REAR COMBINATION LIGHT BODY GASKET
- Remove the rear combination light body gasket.
- REMOVE TAIL LIGHT AND STOP LIGHT BULB
- Turn the tail light and stop light bulb socket and bulb, in the direction indicated by the arrow in the illustration, to remove them.
- Remove the tail light and stop light bulb from the light socket.
- REMOVE TURN SIGNAL LIGHT BULB
- Turn the turn signal light bulb socket and bulb, in the direction indicated by the arrow in the illustration, to remove them.
- Remove the turn signal light bulb from the light socket.
- REMOVE BACK UP LIGHT BULB
- Turn the back up light bulb socket and bulb, in the direction indicated by the arrow in the illustration, to remove them.
- Remove the back up light bulb from the light socket.