REAR COMBINATION LIGHT ASSEMBLY (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL BACK UP LIGHT BULB
1. Install the back up light bulb into the socket.
2. Turn the back up light socket, in the direction indicated by the arrow in the illustration, to install them.
  
  Fig 1: Turning Back Up Light Socket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TURN SIGNAL LIGHT BULB
1. Install the turn signal light bulb into the socket.
2. Turn the turn signal light socket, in the direction indicated by the arrow in the illustration, to install them.
  
  Fig 2: Turning Turn Signal Light Socket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TAIL LIGHT AND STOP LIGHT BULB
1. Install the tail light and stop light bulb into the socket.
2. Turn the tail light and stop light bulb socket, in the direction indicated by the arrow in the illustration, to install them.
  
  Fig 3: Turning Tail Light And Stop Light Bulb Socket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR COMBINATION LIGHT BODY GASKET
1. Install a new rear combination light body gasket.
  
  Fig 4: Identifying Rear Combination Light Body Gasket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR COMBINATION LIGHT ASSEMBLY
1. Install the rear combination light assembly onto the vehicle.
  
  Fig 5: Identifying Rear Combination Light Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the connector.
3. Install the 2 nuts.
  Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf)
  
  Fig 6: Locating Rear Combination Light Assembly Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LUGGAGE COMPARTMENT TRIM INNER COVER
1. Engage the 5 clips and install the luggage compartment trim inner cover.
  
  Fig 7: Locating Luggage Compartment Trim Inner Cover Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR FLOOR FINISH PLATE
1. Engage the 2 clips and install the rear floor finish plate.
  
  Fig 8: Locating Rear Floor Finish Plate Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL DECK FLOOR BOX LH
1. Install the deck floor box and the deck side box door.
INSTALL DECK FLOOR BOX RH
HINT:

Use the same procedure as for the LH side.

Fig 9: Locating Deck Floor Box
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL SPARE WHEEL COVER ASSEMBLY
1. Install the spare wheel cover assembly.
  
  Fig 10: Locating Spare Wheel Cover Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LUGGAGE COMPARTMENT FLOOR MAT
1. Install the luggage compartment floor mat.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

Fig 11: Locating Luggage Compartment Floor Mat
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002