REAR COMBINATION LIGHT ASSEMBLY (for Hatchback): Installation
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY
- Connect the connector and install the rear combination light socket and wire.
- INSTALL REAR COMBINATION LIGHT BULB
- Install the rear combination light bulb into the light socket.
- Turn the rear combination light bulb socket and bulb, in the direction indicated by the arrow in the illustration, to install them.
- Turn the 2 rear combination light bulbs, in the direction indicated by the arrows in the illustration, to install them.
- Engage the 2 claws and install the rear combination light socket and wire.
- INSTALL REAR COMBINATION LIGHT BODY GASKET
- Install a new rear combination light body gasket.
- INSTALL REAR COMBINATION LIGHT ASSEMBLY
- Install the rear combination light assembly onto the vehicle.
- Connect the connector.
- Install the 2 nuts.
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
- INSTALL REAR COMBINATION LIGHT COVER
- Engage the 6 claws and install the rear combination light cover.
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)