HIGH MOUNTED STOP LIGHT ASSEMBLY (for Hatchback): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL HIGH MOUNTED STOP LIGHT ASSEMBLY
1. Engage the 2 claws and install the high mounted stop light.
  
  Fig 1: Identifying High Mounted Stop Light Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CENTER STOP LIGHT COVER
1. Connect the connector.
2. Engage the 2 claws.
  
  Fig 2: Identifying Center Stop Light Cover Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the center stop light cover with the 2 screws.
  NOTE: When reusing the center stop light cover, replace the screws with 90159-60303 screws to avoid insecure installation.
  
  Fig 3: Locating Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Engage the 4 claws and install the rear light cover.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

Fig 4: Locating Rear Light Cover Claws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002