FOG LIGHT ASSEMBLY (for Sedan): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FRONT FENDER LINER
1. Remove the 3 screws and remove the front side of the front fender liner.
  
  Fig 1: Locating Front Fender Liner Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FOG LIGHT ASSEMBLY
1. Disconnect the connector.
2. Remove the 3 screws, then remove the fog light.
  
  Fig 2: Locating Fog Light Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Turn the fog light bulb, in the direction indicated by the arrow in the illustration, to remove it.