FOG LIGHT ASSEMBLY (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FOG LIGHT ASSEMBLY
1. Turn the fog light bulb, in the direction indicated by the arrow in the illustration, to install it.
  
  Fig 1: Turning Fog Light Bulb
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the fog light with the 3 screws.
3. Connect the connector.
  
  Fig 2: Locating Fog Light Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT FENDER LINER
1. Install the 3 screws.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
PREPARE VEHICLE FOR FOG LIGHT AIMING ADJUSTMENT (See ADJUSTMENT )
PREPARE FOR FOG LIGHT AIMING (See ADJUSTMENT )
INSPECT FOG LIGHT AIMING (See ADJUSTMENT )
ADJUST FOG LIGHT AIMING (See ADJUSTMENT )

Fig 3: Locating Front Fender Liner Screws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002