Data List / Active Test
- READ DATA LIST
HINT:
Using a Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List early in troubleshooting is one way to save diagnostic time.
NOTE:In the table below, the values listed under Normal Condition are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- Connect a Techstream to the DLC3.
- Turn the ignition switch ON.
- Turn the tester on.
- Enter the following menus: Body Electrical / Main Body / Data List.
- According to the display on the tester, read on the "Data List".
Main Body:
DATA LIST CHARTItem Measurement Item/Range Normal Condition D Door Courtesy SW Driver side door courtesy light switch signal/ ON or OFF ON: Driver side door is open
OFF: Driver side door is closedD-Door Lock Pos SW Driver side door lock position switch signal/ ON or OFF ON: Driver side door is unlocked
OFF: Driver side door is lockedDoor Lock SW-Lock Door manual lock switch signal/ ON or OFF ON: Door control switch (for front driver door side) is turned to lock position
OFF: Door control switch (for front driver door side) is turned to unlock positionDoor Lock SW-Unlock Door manual unlock switch signal/ ON or OFF ON: Door control switch (for front driver door side) is turned to unlock position
OFF: Door control switch (for front driver door side) is turned to lock positionDoor Key SW-Lock Door key linked lock switch signal/ ON or OFF ON: Driver side door key cylinder is turned to lock position
OFF: Driver side door key cylinder is turned to unlock positionDoor Key SW-Unlock Door key linked unlock switch signal/ ON or OFF ON: Driver side door key cylinder is turned to unlock position
OFF: Driver side door key cylinder is turned to lock positionD Door Key SW-UL Driver side door key linked unlock switch signal/ ON or OFF ON: Driver side door key cylinder is turned to unlock position
OFF: Driver side door key cylinder is turned to lock positionP Door Courtesy SW Passenger side door courtesy light switch signal/ ON or OFF ON: Passenger side door is open
OFF: Passenger side door is closedRR Door Courtesy SW(1) Rear door RH courtesy light switch signal/ ON or OFF ON: Rear door RH is open
OFF: Rear door RH is closedRL Door Courtesy SW(1) Rear door LH courtesy light switch signal/ ON or OFF ON: Rear door LH is open
OFF: Rear door LH is closedBack Door Courtesy SW(2) BACK DOR CTY SW ON: Back door is open
OFF: Back door is closedKey Unlock Warning SW Unlock warning switch / ON or OFF ON: Ignition key is inserted
OFF: Ignition key is not inserted(1) 5 Door, Sedan (2) Hatchback - PERFORM ACTIVE TEST
HINT:
Using a Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non- intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
- Connect a Techstream to the DLC3.
- Turn the ignition switch ON.
- Turn the tester on.
- Enter the following menus: Body Electrical / Main Body / Active Test.
- According to the display on the tester, perform the "Active Test".
Main Body:
ACTIVE TEST CHARTItem Test Details Control Range Door Lock Operate door lock motor LOCK/UNLOCK LOCK or UNLOCK D-Door Unlock Operate driver door lock motor unlock side ON/OFF UNLOCK Hazard Turns turn signal flasher relay ON / OFF OFF/ON