Unlock Warning Switch: Inspection
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT UNLOCK WARNING SWITCH ASSEMBLY
- Check the resistance.
- Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
Standard Resistance
TESTER CONNECTION SPECIFIED CONDITIONTester Connection Condition Specified Condition 1-2 Pin released 10 kΩ or higher 1-2 Pin pushed in Below 1 Ω If the result is not as specified, replace the unlock warning switch.
- Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
- Check the resistance.