Transmitter Battery: Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE TRANSMITTER BATTERY
1. Remove the transmitter battery.
  1. Using a screwdriver with its tip wrapped in protective tape, pry apart the transmitter housing cover.
    NOTE: Do not use excessive force when prying apart the housing cover.
    
    Fig 1: Prying Apart Transmitter Housing Cover
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Remove the door control transmitter module from the transmitter housing case.
    
    Fig 2: Identifying Door Control Transmitter Module
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. Disengage the hook and remove the transmitter battery cover.
    
    Fig 3: Removing Transmitter Battery Cover
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. Remove the battery (lithium battery: CR2016).
    NOTE:
    Do not push the terminals with your finger.
    
    Do not use excessive force when prying up the battery (lithium battery: CR2016) as this may damage the terminals.
    
    Do not touch the battery with wet hands. Water may cause rust.
    
    Do not touch or move any components inside the transmitter as this may interfere with its proper operation.
    
    Fig 4: Identifying Battery
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002