Data List / Active Test

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

READ DATA LIST

HINT:

Using a Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List early in troubleshooting is one way to save diagnostic time.

NOTE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely in these reference values when deciding whether a part is faulty or not.

Connect a Techstream to the DLC3.
Turn the ignition switch ON.
Turn the tester on.
Enter the following menus: Body Electrical / main Body / Data List.
According to the display on the tester, read on the "Data List".

Main body ECU:

DATA LIST

Item	Measurement Item/Display (Range)	Normal Condition
D Door Courtesy SW	Driver side door courtesy switch signal/ ON or OFF	ON: Driver side door is open OFF: Driver side door is closed
D-Door Lock Pos SW	Driver side door lock position switch signal/ ON or OFF	ON: Driver side door is unlocked OFF: Driver side door is locked
Door Lock SW-Lock	Door manual lock switch signal/ ON or OFF	ON: Door control switch (for front driver door side) is turned to lock position OFF: Door control switch (for front driver door side) is turned to unlock position
Door Lock SW-Unlock	Door manual unlock switch signal/ ON or OFF	ON: Door control switch (for front driver door side) is turned to unlock position OFF: Door control switch (for front driver door side) is turned to lock position
Door Key SW-Lock	Door key linked lock switch signal/ ON or OFF	ON: Driver side door key cylinder is turned to lock position OFF: Driver side door key cylinder is turned to unlock position
Door Key SW-Unlock	Door key linked unlock switch signal/ ON or OFF	ON: Driver side door key cylinder is turned to unlock position OFF: Driver side door key cylinder is turned to lock position
D Door Key SW-UL	Driver side door key linked unlock switch signal/ ON or OFF	ON: Driver side door key cylinder is turned to unlock position OFF: Driver side door key cylinder is turned to lock position
P Door Courtesy SW	Passenger side door courtesy switch signal/ ON or OFF	ON: Passenger side door is open OFF: Passenger side door is closed
P-Door Lock Pos SW	Passenger side door lock position switch signal/ ON or OFF	ON: Passenger side door is unlocked OFF: Passenger side door is locked
RR Door Courtesy SW	Rear door RH courtesy switch signal/ ON or OFF	ON: Rear door RH is open OFF: Rear door RH is closed
RL Door Courtesy SW	Rear door LH courtesy switch signal/ ON or OFF	ON: Rear door LH is open OFF: Rear door LH is closed
Back Door Courtesy SW	Back door courtesy switch signal/ ON or OFF	ON: Back door is open OFF: Back door is closed
Key Unlock Warning SW	Unlock warning switch signal/ ON or OFF	ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder

PERFORM ACTIVE TEST

HINT:

Using a Techstream to perform Active Tests allows relays, VSV, actuators and other items to be operated without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Performing Active tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active tests.

Connect a Techstream to the DLC3.
Turn the ignition switch ON.
Turn the tester on.
Enter the following menus: Body Electrical / Main Body / Active Test.
According to the display on the tester, perform the "Active Test".

Main Body:

ACTIVE TEST

Item	Test Details	Control Range
Door Lock	Operate door lock motor LOCK/UNLOCK	LOCK or UNLOCK
D-Door Unlock	Operate driver door lock motor unlock side ON/OFF	UNLOCK