Data List / Active Test

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

READ DATA LIST

HINT:

Using a Techstream to read the Data List allows the values or states of switches, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List early in troubleshooting is one way to save diagnostic time.

NOTE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Turn the tester on.
Enter the following menus: Body electrical / Main Body / Data List
According to the display on the tester, read the "Data List".

Main Body:

DATA LIST CHART

Item	Measurement Item/Range	Normal Condition
Key Unlock Warning SW	Unlock warning switch signal / ON or OFF	ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder
D Door Courtesy SW	Driver side door courtesy switch signal / ON or OFF	ON: Driver side door is open OFF: Driver side door is closed