FRONT DOOR LOCK (for Sedan): Removal
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure described below is for the LH side.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) (See DISASSEMBLY )
- REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (See DISASSEMBLY )
- REMOVE FRONT ARMREST BASE UPPER PANEL (See DISASSEMBLY )
- REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY (See DISASSEMBLY )
- REMOVE OUTER REAR VIEW MIRROR (See REMOVAL )
- REMOVE FRONT DOOR BELT MOULDING (See REMOVAL )
- REMOVE FRONT DOOR TRIM BRACKET (See DISASSEMBLY )
- REMOVE FRONT DOOR SERVICE HOLE COVER (See DISASSEMBLY )
- REMOVE FRONT DOOR GLASS SUB-ASSEMBLY (See DISASSEMBLY )
- REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY (See DISASSEMBLY )
- REMOVE FRONT DOOR GLASS RUN (See DISASSEMBLY )
- REMOVE FRONT DOOR FRAME SUB-ASSEMBLY REAR LOWER (See DISASSEMBLY )
- REMOVE FRONT DOOR OUTSIDE HANDLE COVER (See DISASSEMBLY )
- REMOVE FRONT DOOR LOCK
- Using "Torx" socket wrench T30, loosen the 3 screws.NOTE: Do not drop or damage the front door lock when removing the screws.
- Move the front door lock downward, remove the outside handle frame link and remove the front door lock.
HINT:
Remove the front door lock through the service hole.
- Open the cover.
- Disconnect the front door lock remote control cable and the front door inside locking cable.
- Remove the door lock wire harness seal.
- Using "Torx" socket wrench T30, loosen the 3 screws.