DOOR CONTROL SWITCH (for Sedan): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FRONT ARMREST BASE UPPER PANEL (See DISASSEMBLY )
REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (w/ Power Window)
1. Remove the 3 screws and the power window regulator master switch.
  
  Fig 1: Locating Screws And Power Window Regulator Master Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE DOOR CONTROL SWITCH
1. for Front passenger side with power window: Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the door control switch.
  
  Fig 2: Identifying Claws Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. w/o Power window:
  Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the door control switch.
  
  Fig 3: Identifying Door Control Switch Claws (W/O Power Window)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002