DOOR CONTROL SWITCH (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (w/ Power Window)
1. Install the power window regulator master switch with the 3 screws.
  
  Fig 1: Locating Screws And Power Window Regulator Master Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL DOOR CONTROL SWITCH
1. for Front passenger side with power window: Engage the 2 claws and install the door control switch.
  
  Fig 2: Identifying Claws Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. w/o Power window:
  Engage the 2 claws and install the door control switch.
INSTALL FRONT ARMREST BASE UPPER PANEL (See REASSEMBLY )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

Fig 3: Identifying Door Control Switch Claws (W/O Power Window)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002