Ignition Switch: Inspection
WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT IGNITION SWITCH ASSEMBLY
- Measure the resistance of the switch.
Standard resistance
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
TESTER CONNECTION AND SPECIFIED CONDITIONTester Connection Switch Condition Specified Condition - LOCK 10 kΩ or higher 2 (AM1) - 3 (ACC) ACC Below 1 Ω 2 (AM1) - 3 (ACC)
2 (AM1) - 4 (IG1)
6 (IG2) - 7 (AM2)ON Below 1 Ω 1 (ST1) - 2 (AM1)
1 (ST1) - 4 (IG1)
6 (IG2) - 7 (AM2)
6 (IG2) - 8 (ST2)START Below 1 Ω If the result is not as specified, replace the switch assembly.
- Measure the resistance of the switch.