Rear Wiper Rubber: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR WIPER RUBBER
1. Install the No. 1 and No. 2 backing plates as shown in the illustration.
  NOTE: Install the backing plates facing the correct direction.
  
  Fig 1: Identifying No. 1 And 2 Backing Plates
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Insert the wiper rubber from the front end of the wiper blade to the rear end through the second claw.
3. After pushing the wiper rubber through the rear end claw, allow it to stick out from the rear end stopper.
  
  Fig 2: Inserting Wiper Rubber
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Slide the wiper rubber through the front end claw.
  
  Fig 3: Sliding Wiper Rubber Through Front End Claw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR WIPER BLADE ASSEMBLY
1. Push the wiper blade straight toward the right side of the vehicle to install it to the wiper arm.
  
  Fig 4: Installing Wiper Blade Straight Toward Right Side Of Vehicle
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Lower the arm and blade.
3. Rotate and install the cap.
  
  Fig 5: Identifying Cap
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002