Rear Wiper Motor: Inspection

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT REAR WIPER MOTOR
1. Connect the battery's positive (+) lead to terminal 3 (+B) and the negative (-) lead to terminal 1 (LS).
2. Check that the rear wiper motor operates.
  OK: Rear wiper motor operates.
  
  NOTE: Check that the body ground is connected.
  
  If the result is not as specified, replace the motor.
  
  Fig 1: Identifying Rear Wiper Motor Connector Terminals
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002