Roof Drip Side Finish Moulding: Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.

REMOVE ROOF DRIP SIDE FINISH MOULDING LH
1. Remove the 2 roof drip moulding joint covers from the vehicle body.
2. Remove the roof drip side finish moulding and No. 2 center roof drip side finish moulding.
  NOTE:
  - Do not remove the clips from the vehicle body.
  - If the clips are damaged or removed accidentally, replace them.
  Fig 1: Identifying Roof Drip Side Finish Moulding
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002