Front Bumper: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT BUMPER SIDE RETAINER LH
1. Install the clip and bumper side retainer.
2. Install the bolt.
  Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf)
  
  Fig 1: Identifying Front Bumper Side Retainer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT BUMPER SIDE RETAINER RH
HINT:

Use the same procedures described for the LH side.
INSTALL FRONT BUMPER REINFORCEMENT
1. Install the reinforcement with the 8 bolts.
  Torque: 70 N*m (713 kgf*cm, 51 ft.*lbf)
  
  Fig 2: Identifying Bolts And Reinforcement
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the wire harness and attach the 5 claws.
  
  Fig 3: Identifying Wire Harness Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT BUMPER RETAINER
1. Install the bolt with the retainer.
  
  Fig 4: Identifying Front Bumper Retainer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 FRONT BUMPER ENERGY ABSORBER
1. Install the absorber.
  
  Fig 5: Identifying No. 2 Front Bumper Energy Absorber
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT BUMPER COVER
1. Put protective tape under the front fender and headlight.
2. Install the 4 clips.
  
  Fig 6: Identifying Front Bumper Cover Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the hood cushion center.
  
  Fig 7: Identifying Hood Cushion Center
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. w/Fog Light:
  Connect the 2 fog light connectors.
5. Attach the 4 claws to install the bumper cover.
  
  Fig 8: Identifying Bumper Cover Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Install the 8 screws.
  
  Fig 9: Identifying Front Bumper Cover Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL RADIATOR SUPPORT OPENING COVER
1. Install the 2 clips.
  
  Fig 10: Identifying Radiator Support Opening Cover Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL RADIATOR GRILLE PROTECTOR
1. Install the 2 radiator grille protectors.
  
  Fig 11: Identifying Radiator Grille Protectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT FENDER LINER LH
1. Install the fender liner with the fender liner retainer.
2. w/Splash Shield:
  Install the front fender splash shield LH.
  
  Fig 12: Identifying Front Fender Splash Shield LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the screw, nut and bolt.
INSTALL FRONT FENDER LINER RH
HINT:

Use the same procedures described for the LH side.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL