Purge Valve: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL PURGE VSV
1. Install the purge VSV with the bolt.
  Torque: 10 N*m (102 kgf*cm, 7 in.*lbf)
2. Connect the 2 purge line hoses to the purge VSV.
3. Connect the wire harness clamp.
4. Connect the purge VSV connector.
Fig 1: Identifying Purge VSV
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL