Fuel Tank: Reassembly

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FUEL SENDER GAUGE ASSEMBLY
1. Install the sender gauge with the 5 screws.
  Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf)
  
  Fig 1: Identifying Sender Gauge With Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 FUEL TANK CUSHION
1. Install 7 new fuel tank cushions onto the fuel tank as shown in the illustration.
  
  Fig 2: Identifying Fuel Tank Cushions From Fuel Tank
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 FUEL TUBE CLAMP
1. Install the 4 tube clamps to the fuel tank.
  
  Fig 3: Identifying Tube Clamps From Fuel Tank
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
1. Install the tube to the 4 fuel tube clamps (see Fig 3).
INSTALL FUEL SUCTION WITH PUMP ASSEMBLY (See appropriates step(s) under INSTALLATION )
INSTALL FUEL TANK VENT TUBE SET PLATE (See INSTALLATION )
CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY (See INSTALLATION )