On-Vehicle Inspection

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT NO. 1 COOLING FAN MOTOR

Disconnect the No. 1 fan connector.
Connect the battery and ammeter to the No. 1 fan motor connector.

Fig 1: Connecting Battery And Ammeter To No. 1 Fan Motor Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Check that the No. 1 fan rotates smoothly, and then check the reading on the ammeter.

Standard amperage

STANDARD AMPERAGE SPECIFIED CONDITION CHART

Indication Mark	Motor Type	Condition	Specified Condition
B, C	160 W	At 20°C (68°F)	11.7 to 14.7 A

HINT:

Refer to the illustration for the indication mark location. (See Fig 1).

If the result is not as specified, replace the No. 1 cooling fan motor.

Reconnect the No. 1 fan motor connector.

INSPECT NO. 2 COOLING FAN MOTOR

Disconnect the No. 2 fan connector.
Connect the battery and ammeter to the No. 2 fan motor connector.

Fig 2: Connecting Battery And Ammeter To No. 2 Fan Motor Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Check that the No. 2 fan rotates smoothly, and then check the reading on the ammeter.

Standard amperage

STANDARD AMPERAGE SPECIFIED CONDITION CHART

Indication Mark	Motor Type	Condition	Specified Condition
B	120 W	At 20°C (68°F)	8.4 to 10.4 A
C	160 W	At 20°C (68°F)	11.7 to 14.7 A

HINT:

Refer to the illustration for the indication mark location. (See Fig 2).

If the result is not as specified, replace the No. 2 cooling fan motor.

Reconnect the No. 2 fan motor connector.