Oil Pump: Reassembly

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL OIL PUMP ROTOR
1. Coat the drive rotor and driven rotor with engine oil.
2. Place the drive and driven rotors into the oil pump with the marks facing the pump cover side.
  
  Fig 1: Installing Drive & Driven Rotors Into Oil Pump
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL OIL PUMP COVER
1. Install the oil pump cover with the 5 bolts.
  Torque: 8.8 N*m (90 kgf*cm, 78 in.*lbf)
  
  Fig 2: Installing Oil Pump Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL OIL PUMP RELIEF VALVE
1. Coat the relief valve with engine oil.
2. Insert the relief valve and spring into the pump body hole.
3. Using a 27 mm socket wrench, install the plug.
  Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
  
  Fig 3: Inserting Relief Valve & Spring Into Pump Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL OIL PUMP STRAINER
1. Install a new gasket and the oil strainer with the 2 nuts.
  Torque: 8.8 N*m (90 kgf*cm, 78 in.*lbf)
  
  Fig 4: Installing Gasket & Oil Strainer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002