Child Restraint Seat Tether Anchor: Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

HINT: Refer to appropriate step(s) under "Removal and Disassembly".

REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER
1. Using a screwdriver, detach the 4 claws and remove the cover.
  
  Fig 1: Removing Child Restraint Seat Tether Anchor Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Tape the screwdriver tip before use.
REMOVE ROOF HEADLINING ASSEMBLY
HINT:

It is not necessary to completely remove the roof headlining. Slightly lower the rear section of the roof headlining.
1. Partially remove the roof headlining (see REMOVAL ).
REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET
1. Remove the bolt and bracket.
  
  Fig 2: Removing Child Restraint Seat Tether Anchor Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CHILD RESTRAINT SEAT PROTECTOR