FRONT SEAT ASSEMBLY (for Manual Seat): Installation

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the RH side.

1. INSTALL FRONT SEAT ASSEMBLY 
   1. Place the seat in the cabin.
      NOTE: Be careful not to damage the vehicle body.
   2. Connect the connector under the seat.
   3. Lift up the seat track adjusting handle and move the seat to the rearmost position.
   4. Tighten the 2 bolts on the front side of the seat.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

      Fig 1: Tightening Bolts On Front Side Of Seat

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT:

      Tighten the bolts in the order indicated in the illustration.

   5. Lift up the seat track adjusting handle and move the seat to the foremost position.
   6. Tighten the 2 bolts on the rear side of the seat.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

      Fig 2: Tightening Bolts On Rear Side Of Seat

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT:

      Tighten the bolts in the order indicated in the illustration.

2. INSPECT AND ADJUST SEAT SLIDE ADJUSTER LOCKS 
   1. During sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously.

      If the seat adjusters do not lock simultaneously, loosen the seat fixation bolts to adjust the adjuster's position.

3. INSTALL FRONT SEAT TRACK BRACKET OUTER COVER LH 
   1. Install the outer cover in the direction indicated by the arrow in the illustration and attach the 2 claws.
      Fig 3: Installing Front Seat Track Bracket Outer Cover

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. INSTALL FRONT SEAT TRACK BRACKET INNER COVER LH 
   1. Install the inner cover in the direction indicated by the arrow in the illustration and attach the 2 claws.
      Fig 4: Installing Front Seat Track Bracket Inner Cover

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. INSTALL FRONT SEAT HEADREST ASSEMBLY 
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
7. CHECK SRS WARNING LIGHT (w/Front Seat Side Airbag) 
   1. Check the SRS warning light (see \DIAGNOSIS SYSTEM ).
8. INSPECT FRONT SEAT ASSEMBLY 
   1. for Passenger Side:

      Perform the zero point calibration and sensitivity check (see PROBLEM SYMPTOMS TABLE ).

   2. w/Seat Heater System:

      Check the seat heater operation.

      1. Turn the ignition switch on (IG).
      2. Push the seat heater switch ON.
      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.